How To Use The TREX Communicator To Setup The Rosemount 3051 Pressure Transmitter?

1. Turn on the machine and connect the TREX  to the Rosemount 3051 pressure transmitter;
2. After successful communication, select Configuration - Manual Settings - Process Variables - Pressure Settings - Pressure Units - Select the corresponding unit - Send

1. Turn on the machine and connect the TREX communicator with the Rosemount 3051 pressure transmitter;
2. After the communication is successful, select configuration - manual setting - analog output - set range point;
3. Enter the upper limit of the actual range required by the main variable, and click OK;
3. Enter the lower limit of the range actually required by the main variable, and click OK;
4. Finally, click Send.

1. Turn on the machine and connect the TREX communicator with the Rosemount 3051 pressure transmitter;
2. After the communication is successful, select the configuration - setting wizard - basic setting - measurement/damping unit - damping;
3. Enter the desired damping value
4. Click OK
5. Send--Send--OK.

1. Turn on the machine and connect the TREX communicator with the Rosemount 3051 pressure transmitter;
2. After the communication is successful, select the configuration - manual setting - process variable - pressure setting - conversion function
3. Select the desired function (linear or square root) - OK
4. Send

1. Turn on the machine and connect the TREX communicator with the Rosemount 3051 pressure transmitter;
2. After the communication is successful, select Configuration--Setup Wizard--Basic Settings--Device Number
3. Enter the required tag
4. Sure
5. Send